Teldat bintec W1002n Manual do Utilizador Página 275
- Página / 554
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
Caution
Make sure you don’t lock yourself out when configuring filters:
If possible, access your gateway for filter configuration over the serial console interface
or ISDN Login.
12.5.1 Access Filter
This menu is for configuration of access filter Each filter describes a certain part of the IP
traffic and defines, for example, the IP addresses, the protocol, the source port or the des-
tination port.
A list of all access filters is displayed in the Networking->Access Rules->Access Filter
menu.
Fig. 112: Networking->Access Rules->Access Filter
12.5.1.1 Edit or New
Choose the icon to edit existing entries. To configure access fitters, select the New but-
ton.
Teldat GmbH
12 Networking
bintec WLAN and Industrial WLAN 261
- Reference 1
- Legal Notice 2
- Manual Teldat GmbH 2
- Table of Contents Teldat GmbH 10
- Table of Contents 11
- Chapter 1 Introduction 15
- 1 Introduction Teldat GmbH 16
- Chapter 2 About this guide 17
- 2 About this guide 19
- Chapter 3 Installation 20
- 3 Installation 21
- Installation 22
- 3 Installation Teldat GmbH 22
- 3.1.2 Connectors 23
- 3.1.3 LEDs 24
- 3.1.4 Scope of supply 25
- 3.1.6 Reset 27
- 3.2 bintec W1002n 28
- 3.2.2 Connectors 31
- 3.2.3 Antenna connectors 32
- 3.2.4 LEDs 32
- 3.2.5 Scope of supply 33
- 3.2.7 Reset 35
- 3.3.2 Connectors 39
- 3.3.3 Antenna connectors 40
- 3.3.4 LEDs 40
- 3.3.5 Scope of supply 42
- 3.3.7 Reset 46
- 3.4.2 Connectors 50
- 3.4.3 Antenna connectors 51
- 3.4.4 LEDs 52
- 3.4.5 Scope of supply 53
- 3.4.7 Reset 56
- 3.5 Cleaning 57
- 3.6 Pin Assignments 57
- 3.6.2 Serial interface 59
- 3.6.3 Socket for power supply 59
- 3.7 Frequencies and channels 60
- 3.8 Support information 60
- 3.9 WEEE information 61
- Chapter 4 Basic configuration 62
- 4.1.2 Software update 63
- 4.2 System requirements 64
- 4.3 Preparation 64
- 4.3.2 Configuring a PC 66
- 4.4 IP configuration 67
- GUI Call up 69
- 4.5 Modify system password 70
- 4.7 Setting up a bridge link 71
- 4.8 Software Update 73
- 5.1 Access Options 74
- 5.1.1.2 Telnet 75
- 5.1.1.3 SSH 75
- 5 Access and configuration 75
- 5.2 Login 79
- 5.3 Configuration options 80
- 5.3.1 GUI for advanced users 81
- 5.3.1.1 Calling up GUI 82
- 5.3.1.2 Operating elements 82
- Fig. 37: Filter list 88
- 5.3.1.3 GUI Menus 90
- 5.4 BOOTmonitor 91
- Fig. 38: BOOTmonitor 92
- Chapter 7 System Management 94
- 7.2 Global Settings 97
- 7.2.2 Passwords 100
- 7.2.3 Date and Time 101
- ISDN/Manual 102
- Time server 102
- Teldat GmbH 103
- 7 System Management 103
- 7.2.4 System Licences 106
- 7.2.4.1 Edit or New 107
- Routing versus bridging 108
- 7.3.1 Interfaces 110
- 7.3.1.1 Add 111
- 7.4 Administrative Access 113
- 7.4.1.1 Add 114
- 7.4.2 SSH 115
- 7.4.3 SNMP 119
- 7.5 Remote Authentication 120
- RADIUS packets 121
- 7.5.1.1 Edit or New 122
- 7.5.2 TACACS+ 126
- 7.5.3 Options 129
- 7.6 Certificates 130
- 7.6.1 Certificate List 131
- 7.6.1.2 Certificate Request 134
- 7.6.1.3 Import 139
- 7.6.2 CRLs 140
- 7.6.2.1 Import 141
- 7.6.3 Certificate Servers 142
- Chapter 8 Physical Interfaces 143
- 8.2 Serial Port 145
- 8 Physical Interfaces 147
- 8.3 Relay 149
- Chapter 9 LAN 151
- Example of subnets 152
- 9.1.1.1 Edit or New 152
- 9 LAN Teldat GmbH 152
- 9.2 VLAN 155
- 9.2.1 VLANs 157
- 9.2.2 Port Configuration 158
- 9.2.3 Administration 158
- Chapter 10 Wireless LAN 160
- 10.1 WLAN 161
- 10 Wireless LAN Teldat GmbH 162
- 10 Wireless LAN 163
- Setting network names 176
- Security measures 178
- 10.1.2.1 Edit or New 178
- 10.1.3 WDS Links 185
- 10.1.3.1 Edit or New 186
- 10.1.4 Client Link 188
- 10.1.4.2 Client Link Scan 190
- 10.1.5 Bridge Links 191
- 10.1.5.1 Edit or New 197
- 10.1.5.2 Bridge Links Scan 198
- 10.2 Administration 200
- 11.1 Wizard 201
- 11.1.1 Basic Settings 202
- 11.1.2 Radio Profile 203
- 11.1.3 Wireless Network 203
- 11 Wireless LAN Controller 205
- 11.2 Controller Configuration 207
- 11.3 Slave AP configuration 209
- 11.3.1 Slave Access Points 210
- 11.3.1.1 Edit 211
- 11.3.2 Radio Profiles 214
- 11.3.3.1 Edit or New 221
- ->New 222
- 11.4 Monitoring 228
- 11.4.3 Load Balancing 229
- 11.4.4 Neighbor APs 230
- 11.4.5 Rogue APs 231
- 11.4.6 Rogue Clients 232
- 11.5 Maintenance 233
- Chapter 12 Networking 236
- 12 Networking 237
- 12 Networking Teldat GmbH 238
- 12.1.2 IPv4 Routing Table 242
- 12.1.3 Options 243
- 12.2 NAT 244
- 12.2.2 NAT Configuration 246
- 12.3 Load Balancing 252
- 12.3.2.1 Edit or New 257
- 12.4 QoS 260
- 12.4.2 QoS Classification 263
- 12.4.3.1 New 267
- 12.5 Access Rules 273
- 12.5.1 Access Filter 275
- 12.5.2 Rule Chains 279
- 12.5.3 Interface Assignment 280
- 12.5.3.1 Edit or New 281
- 12.6 Drop In 282
- Chapter 13 Routing Protocols 286
- 13 Routing Protocols 287
- 13.1.2 RIP Filter 288
- 13.1.2.1 New 289
- 13.1.3 RIP Options 291
- Chapter 14 Multicast 294
- 14.1 General 295
- 14.2 IGMP 296
- 14.2.1 IGMP 297
- 14 Multicast Teldat GmbH 298
- 14.2.2 Options 299
- 14.3 Forwarding 301
- 14.4 PIM 302
- 14.4.1.1 Edit or New 303
- 14 Multicast 303
- 14.4.2 PIM Rendezvous Points 306
- 14.4.3 PIM Options 307
- Chapter 15 WAN 309
- Authentication 310
- Default Route 310
- Activating NAT 310
- Connection Idle Timeout 310
- 15.1.1 PPPoE 311
- 15 WAN Teldat GmbH 312
- 15.1.2 PPTP 316
- 15.1.3 IP Pools 321
- 15.2 Real Time Jitter Control 322
- 15.2.1.1 New 323
- Chapter 16 VPN 324
- 16.1.1 IPSec Peers 325
- Peer Monitoring 326
- 16.1.1.1 New 326
- 16 VPN Teldat GmbH 326
- 16.1.2 Phase-1 Profiles 341
- 16.1.3 Phase-2 Profiles 349
- 16.1.4 XAUTH Profiles 354
- 16.1.5 IP Pools 356
- 16.1.6 Options 357
- 16.2 L2TP 360
- 16.2.1 Tunnel Profiles 361
- 16.2.2 Users 364
- 16.2.3 Options 370
- 16.3 GRE 371
- 16.3.1.1 New 372
- Chapter 17 Firewall 374
- IP Access Lists 375
- 17.1 Policies 375
- 17.1.1.1 New 376
- 17 Firewall Teldat GmbH 376
- 17 Firewall 377
- 17.1.2 QoS 379
- 17.1.3 Options 380
- 17.2 Interfaces 382
- 17.3 Addresses 383
- 17.3.2 Groups 384
- 17.4 Services 385
- 17.4.2 Groups 387
- Chapter 18 Local Services 389
- 18 Local Services Teldat GmbH 390
- 18.1.1 Global Settings 391
- 18.1.2 DNS Servers 393
- 18.1.3 Static Hosts 395
- 18.1.4 Domain Forwarding 396
- 18.1.4.1 New 397
- 18 Local Services 397
- 18.1.5 Cache 398
- 18.1.6 Statistics 399
- 18.2 HTTPS 400
- 18.3 DynDNS Client 401
- 18.3.2 DynDNS Provider 403
- 18.4 DHCP Server 405
- 18.4.2 DHCP Configuration 406
- 18.4.2.1 Edit or New 407
- 18.4.3 IP/MAC Binding 410
- 18.4.4 DHCP Relay Settings 411
- 18.5 Scheduling 412
- 18.5.1 Trigger 413
- 18.5.2 Actions 418
- 18.5.3 Options 429
- 18.6 Surveillance 430
- 18.6.2 Interfaces 433
- 18.6.3 Temperature 434
- 18.6.3.1 Edit or New 435
- 18.6.4 Ping Generator 436
- 18.7 Teldat Discovery 437
- 18.8 HotSpot Gateway 440
- Requirements 441
- 18.8.1 HotSpot Gateway 442
- 18.8.2 Options 446
- Chapter 19 Maintenance 447
- 19.1.2 DNS Test 448
- 19.1.3 Traceroute Test 448
- 19.2.1 Options 449
- Configuration file format 450
- 19 Maintenance Teldat GmbH 450
- 19 Maintenance 451
- 19.3 Reboot 455
- Chapter 20 External Reporting 456
- 20.1.1.1 New 457
- 20 External Reporting 457
- 20.2 IP Accounting 459
- 20.3 Alert Service 461
- 20.3.2 Alert Settings 464
- 20.4 SNMP 466
- 20.4.2 SNMP Trap Hosts 467
- 20.5 Activity Monitor 468
- 20.5.1 Options 469
- Chapter 21 Monitoring 471
- 21.2 IPSec 472
- 21 Monitoring 473
- 21.2.2 IPSec Statistics 474
- 21.3 Interfaces 475
- 21 Monitoring Teldat GmbH 476
- 21.4 WLAN 478
- 21.4.2 VSS 480
- 21.4.3 WDS 483
- WDS Link Details 484
- 21.4.4 Bridge Links 486
- Bridge link details 487
- 21.4.5 Client Links 488
- Client Link Details 489
- 21.5 Bridges 490
- 21.6 HotSpot Gateway 491
- 21.7 QoS 492
- 21.8 PIM 492
- 21.8.1 Global Status 493
- Glossary 501
- Glossary Teldat GmbH 502
- Index Teldat GmbH 542
© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.024 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais